The IC693BEM341 is a FIP bus controller module in the 90-30 series Programmable Logic Controller (PAC) family, formerly manufactured by GE Fanuc Automation and now owned by Emerson Automation. The module comes with two (2) 9-pin D-shell connectors, Factory Instrumentation Protocol (FIP) support for 2.5MHz data rate and an RS485 communication port for firmware upgrades. The module can be used to connect to the 90-70 series through the configuration of the DIP switch. It features four (4) LED status indicators, such as a CD1 / CD2 carrier detector LED and an LED that supports TEN1 / TEN2 transmission.
The IC693BEM341 is a Factory Instrumentation Protocol (FIP) compatible module that belongs to Emerson Automation's Series 90-30 Programmable Logic controller (PLC) family and was previously manufactured by GE Fanuc Automation.
The IC693BEM341 controller is a FIP bus controller designed and manufactured by GE Fanuc. This part belongs to the GE series 90-30. This particular controller model is an upgrade over the old bus controller and it includes different innovative features. When comparing this model with older models such as the GE 340 controller, they are functionally identical except for the increased network speed in the new IC693BEM341 model. The GE Fanuc IC693BEM341 FIP bus controller is a 2.5 MHZ version of the bus controller. It is also available with firmware version 3.01. This bus controller requires any IC693 PLC CPU version 8.10 or later. Another configuration requirement for this fieldbus controller is that it requires a handheld programmer or HHP. This HHP has programming software developed by Windows and it should be version 2.0 or later. The FBCLOAD configuration utility must be used to configure the controller to function properly on the network.
The GE Fanuc IC693BEM341 FIP Bus controller supports configuration mode 30. This mode is an extension of Configuration Mode 11 compared to previous versions of the bus controller, which adds different features such as redundancy, management, and monitoring functions to slave devices including I/O nesting, drives, PLCS, and control stations. It can also timestamp Booleans and handle the reception of messaging services and external configurations over the FIP network. Some of the updates provided in the GE Fanuc IC693BEM341 FIP bus controller are designed to address a previous issue that caused the PLC CPU to lose module failures reported when there were no such failures. Another problem that has been corrected is that the status of PLC applications is often incorrectly determined.
| GE IS215ACLEH1AB Mark VI Control Module |
| GE Fanuc IS215UCVEM10A | VME CPU Card | Mark VIe Distributed Control System |
| GE 04220FL11232A Ethernet Controller Module |
| GE Fanuc IS215UCVEM06A | Ethernet connection control board |
| GE 336A4940CSP6 | IS220PRTDH1A | Resistance Temperature Device (RTD) Input Module |
| GE IS220PDIAH1A | 336A4940CSP1 | MKVIe 24 Discrete Contact in I/O Pack |
| GE DS200DMCBG1AED | DS200DMCBG1AKG | Mark V DS200 Speedtronic Drive Board |
| GE IS220PAOCH1A | 336A4904CSP5 | Speedtronic Mark VIe | Analog Out |
| GE 369-LO-0-M-F-E-0-0 Motor Management Relay |
| GE 369-HI-R-M-0-0-0-0 Motor Management Relay |
| GE 369-HI-0-0-0-0 | Multilin 369 Motor Management Relay |
| GE IS420UCSBH1A | Ethernet switch | 6 port |
